SOA, drill the frame or use bracket?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 13, 2003
Threads
71
Messages
786
Location
Folsom, CA
All these threads on SOA and kits, got me thinking again about my SOA. I really do not like the idea of drilling holes in the frame for the back of the front springs shackle bolt. Anyone use a good bracket that puts the bolt and sleeve below the frame so frame is not drilled?
 
if you can go through the frame, My headers were in the way so I had to go below the frame, I think I may try and get a stock manifold and redo this work and go through the frame to lower my front a inch. I may also have issues with my drag link hitting on my spring because of the large angle on the spring sloping backward I havn't flexed it yet so I don't know but it is close.

Anyway for your question, I used the stock shackle mount flipped upside down ground on the top so that the eye is as close to the frame as posible and so that it is boxed underneith, I then notched the bottem just to make it look pretty.
here is a pic
note that i am outboarded and that I hadn't boxed the sides of that mount yet

so15.JPG
 
cardinal fang said:
All these threads on SOA and kits, got me thinking again about my SOA. I really do not like the idea of drilling holes in the frame for the back of the front springs shackle bolt. Anyone use a good bracket that puts the bolt and sleeve below the frame so frame is not drilled?

I drilled the frame for mine, but what about something like the "frenched" spring hangers that Marlin sells for Totoyas?

Rear hangers

hangerinst_500.jpg
 
I used the original that was on the front of the front springs on the back when I did the SR. Worked fine for a long time. Did my engine swap so now have it through the frame, header was in the way before.
fshackle03.webp
 
Back
Top Bottom