SM465 adapter plate collar

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Who's adapter plate?


Please post up a pic...


Does this collar slip over the output side of the tranny mainshaft?


Could it be to space the Toyota tcase drive gear proper to the other gears in the case?



Little help Dallas... :)


Could it be a spacer like what Treeroot was talking about in these posts?

https://forum.ih8mud.com/showthread.php?t=25753&page=8&pp=30
 
Is it the sleeve to build up the outside of the front bearing retainer of the tranny to fit the Toyota trowout bearing?
 
dmaddox said:
Do I need it/mandatory?



I would install it, without question if it lines the gears up....



Did you read through Mikes write up in the Orion link, and how the gear walked in and out on the output shaft of the 465 tranny, and machined the case?


I would put it in there.


Good luck!


-Steve
 
Back
Top Bottom