Slow To Lock Center Diff Lock

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

LFD2037

TEXAS LEXUS!
Joined
Oct 22, 2013
Threads
183
Messages
3,889
Location
Wax., TEXAS
When I engage center diff lock & put it into low, recently it has been taking 1+ miles to get it to actually engage & for the diff lock & ABS light to come on. Once it does engage, I can disengage & re-engage no problem & w/no delay. Why does it take so long to engage when I haven't engaged it recently & how do I speed up this slow process? Thanks.


***ETA***
After more google-fu I came up w/these 2 links that should have all the aspects of testing the CDL covered.
CDL Sensor/Switch
Troubleshooting the Toyota FJ80 Land Cruiser Center Diff Lock (CDL) - Pacific Northwest Backroad Adventures

Thanks to George & whomever the guy was that did the PNW write-up!
 
Last edited:
Recently had this issue. My actuator needed pulled out and cleaned up. It got progressively worse over time. Lucky I have a local LC guru that was able to knock out the work for me. @Tools R Us
Hmmmmm. Do you know what this process entails? Thanks.
 
Have you put on stands and tested? Takes a certain amount of offset between tires to mesh and lock up.
 
Hmmmmm. Do you know what this process entails? Thanks.

Not completely. Access is on top of t case. I think four bolts and it comes up and out. Looked like a few little parts (springs?), that's when I punted on the work. Kind of tough access from what I've read.
 
Have you put on stands and tested? Takes a certain amount of offset between tires to mesh and lock up.
It is w/out a doubt functioning. It's just lethargic.
 
Does anyone know of a write-up for R&R the CDL? I tried google but nothing comes up for an FZJ. Thanks.
 
The DL's (all of them), need regulars 'exercising', to keep them moving. The CDL also has a breather that is linked to the trans brwather, so moisture, can get in there, or the grease on the cogs dries out.

I fitted independent breathers, if need be I could flood the centre DL with gear oil which may save dismantling if not at a convenient time.

Regards

Dave
 
The DL's (all of them), need regulars 'exercising', to keep them moving. The CDL also has a breather that is linked to the trans brwather, so moisture, can get in there, or the grease on the cogs dries out.

I fitted independent breathers, if need be I could flood the centre DL with gear oil which may save dismantling if not at a convenient time.

Regards

Dave
Seeing as it engages normally after the initial engagement, I'll first try using it @ least once a month & see how that goes. I've been so busy lately I haven't been wheelin' as often as I usually do so hopefully just working it cures my issue. Thanks.
 
Back
Top Bottom