slow front and rear diff lock maintenance?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 18, 2007
Threads
7
Messages
16
Location
New Zealand
Sometimes my front and rear diff locks are slow to engage. I have researched all the threads and know all the stuff about being under 5MPH, turning in circles on loose ground, and giving them a good work out off/on to loosen them up....all of which I've done. I know the mtors are activating as I hear them wind for a few seconds when I turn the switch.
I'm just wondering if I can safely remove the actuator cover to do a little bit of maintenance like inspect for dirt/rust and apply a bit of grease to the gears and springs without actually removing the whole actuator assembly from the diff? Can the actuator cover be removed and put back in place easily enough whilst still attached to the diff or will everything jump out at me once I remove the actuator cover and leave me saying :doh:?
 
NZcruiser,
I have not done this maintenance but others have. I believe you can find a good write-up for both the front, rear, and center diff lock mechanisms. So, the answer to your question is, Yes, you can rebuild and lube the assembly. I don't know if it can be done while on the diff but I am sure the removal is easy in comparison to the disassembly and rebuild.

You need to read the prior write-ups because there are things that will jump out at you once you remove the actuator cover. I would not attempt this without the FSM for your vehicle.

-B-
 
Thanks Beowulf,

Sorry I should have expalined I have all the links already to rebuid the whole assembly. What I am specifically trying to find out is if I can just take the actuator cover off safely whilst still in place so i can inspect for rust or relube if required as a full rebuild may not be necessary if it all ooks good inside. They are still working...just slow sometimes...so i'm trying to avoid a full rebuild if not required.
 
Back
Top Bottom