slave cylinder ??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 27, 2005
Threads
183
Messages
471
Location
San Jose CA
I have a 9/'71 engine w/ a 4 spd and manual xfer. The tran and xfer may(!) be a different year. The slave cyl from my original '70 doesn't seem to fit on the PASSENGER side, which is where the clutch fork is sticking out. I've been told repeatedly that the F engine always had the slave on the driver's side.

If I order a 'new' clutch slave, any ideas what the heck I should ask for?
 
When I installed a 4 spd in my 66 FJ40 I was adding a new 2F also. I had to switch the clutch slave to the pass side and used the tranny mount that had a place to mount it. If this wasn't changed during the swap, you might need to get one in there for a place to mount the slave. I had to modify my t/c linkage to fit around the slave also. This sounds like what you are referring to anyway.
 
The slave cylinder will bolt to the flywheel housing, you will need to change the acctuation rod...iirc.


Good luck!


-Steve
 
I recently had to do this as well
Make sure you check the fitting size.
My replacements fittings were smaller so I retro fitted them
 
I'm going through this right now. Wanted to keep the slave on the driver's side, but on the 4 speed, there is no provision to mount the slave on the driver's side. The slave actually mounts to the support attached to the bellhousing, aka, motor mount. Whatever you call it, there are four of them and two attach to the bellhousing. I decided to keep it on the pass side and bend up a hard line from the master to the rubber hose.
I posted a question earlier about using my 3 speed "motor mount", on the 4 speed bellhousing, but the answer was that the slave for the 4 speed would not mount to the 3 speed mount. Confused? so am I.


Ed
 
Degnol said:
I'm going through this right now. Wanted to keep the slave on the driver's side, but on the 4 speed, there is no provision to mount the slave on the driver's side. The slave actually mounts to the support attached to the bellhousing, aka, motor mount. Whatever you call it, there are four of them and two attach to the bellhousing. I decided to keep it on the pass side and bend up a hard line from the master to the rubber hose.
I posted a question earlier about using my 3 speed "motor mount", on the 4 speed bellhousing, but the answer was that the slave for the 4 speed would not mount to the 3 speed mount. Confused? so am I.


Ed

I stand corrected...not a tranny mount, not a motor mount but a bellhousing mount? It probably is referred to as a rear motor mount. Is that what is meant by attaching it to the bellhousing? I can post a pic if needed. Looks like with either rear motor mount, the slave could be on either side. I was glad to move it over to the pass side away from the exhaust.
 
Back
Top Bottom