Shuddering

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 22, 2009
Threads
15
Messages
42
Location
Manitouwadge, ON
I just traded up my 87 4runner for a 1991 FJ80 and had a chance to really test it out this weekend. I noticed a shuddering when I hit about 30 then it goes away which it wasn't doing during the test drive how convenient. I'm also getting some vibrating during highway speeds and was wondering if anyone had a good idea on where to start looking for this problem.
Thanks
 
The shuddering only occurs on acceleration. If I let off the gas when it's doing this the shuddering stops. I know what it feels like when tires aren't balance and it doesn't feel like this is my problem, but I guess it's a good start.
 
What about tire wear? I had a set of 32's that would vibrate 40-50 MPH, then anything over 60. Two of them were worn badly on one side.
 
i don't know about "shuddering" but any vibration that is specific to aceleration or deceleration can be atributed to driveline angle. Is it lifted? If not check the U-Joints. If yes have a shop check the angles at the t-case output and the rr axle input(pinion.) If you are using the factory driveshaft there should be no more tha a 4 degree difference in the angles. Also check the control arm bushings. If your angles are close to the 4 degrees of difference and your bushings are shot, it will allow the pinion to rise while accelerating and the angle to be higher than 4 degrees. So just because the angles are ok while sitting static does not meen they stay that way. Oh yah, check the front as well. Good luck.
 
I purchased the cruiser completely stock. I'll have to get the tires checked out and balanced first to rule that out then put it up on the hoist and do some snooping around. Thanks for all the input
 
that seems to be a good idea. balance the tires first since it is the simplest and cheapest. from there, lubricate the drive shaft propeller. is your fj80 an auto tranny? because my hdj81 had a vibration at some speed, then vibration goes off when reducing speed (easing on accelerator). did the exact same. balanced tires, then lubriated drive shaft propeller and still vibrated. the last step was to check the tranny. the bushings of the torque converter gave and affected everything inside. pan had lots of metal shavings. so the wisest thing to do was get an assembly. problem solved. no more vibrations
 
If you have two sets of jack stands you can find out if it is coming from the front or rear tires by removing each set and getting the driveline up to speed. You could also use this method to see if a driveshaft is the culprit, by removing the front and/or rear and repeating the above procedure.
 
Do a search on fuel pressure regulator on a 3FE started by a user named yooper. I may have the details wrong, but I think his FJ62 had similar problems that ended up creating a fuel starved situation.
 
I had this same 'type' of issue recently too. I am lifted front & rear w/ OME heavy 2.5''. Found it to be that the front propeller shaft was out of balance.:hhmm:
170k on a '94. Just old age and fix is complete replacement.

Good Luck
 
Back
Top Bottom