Shock questions

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 20, 2009
Threads
5
Messages
85
Location
Vancouver, BC
Here is my 2nd newb thread.

I searched for information about shocks but only found a thread about aftermarket info.

My question is regarding the OEM shocks.

I am looking to replace shocks on my LX450. I remember reading somewhere that LX450 has a softer suspension setup then LCs. So I was wondering whether the shocks are same/interchangeable.

A Toyota dealer quoted $63 per shock for LC, and Lexus quoted me $51 per shock. Just trying to figure out the differences. I would also welcome suggestions to which one I should get.

Furthermore, I also asked Lexus how much is the labor cost for them to replace. I was shocked (no pun intended)!!! 1.5hr per shock LOL:bang:, at $115 hourly rate this shock job would cost me $700 for the labor.

The question is obvious....1.5hr per shock? Is there something tricky with the process?? :confused:
 
I dont know about the difference in the shocks, but ill tell you that it will not take 1 1/2 per shock to change.

With basic tools you can easily change the front two in about 20 minutes. The rear might take a little longer because the top of the shocks mount on a special plate, then that plate mounts onto the chasis. Still pretty simple. I think you it might be easier with the rear wheels off.

Here is a link to Slee's installtion insructions:
Slee - OME Suspension Installation (Toyota 80 Series Land Cruiser)
 
What is wrong with your original shocks? If you just want to replace them, I have a set of OEM Lexus rear shocks with only 55,000 miles on them. Let me know if you are interested.
 
Thanks for the Slee link, it seems easy enough for me to tackle.

My shocks are rusted, and seem rather soft. And I'd rather get a matching set, thnx for the offer.

But no one commented on whether the shocks on LC and LX450 are different, and whether they are interchangeable.
 
Thanks for the Slee link, it seems easy enough for me to tackle.

My shocks are rusted, and seem rather soft. And I'd rather get a matching set, thnx for the offer.

But no one commented on whether the shocks on LC and LX450 are different, and whether they are interchangeable.

Yes the LX & LC shocks are the same size, fittings, so are interchangeable. The original stock LX shocks were softer valved, so the LC shocks are a firmer upgrade. IIRC a set of LC shocks are ~$120 from CDan?
 
Thanks for the post. Im up in Vancouver BC, so getting the parts shipped across the border can be a pain. $60CDN quoted by toyota is rather reasonable to me.
 
So I was wondering whether the shocks are same/interchangeable.

The shocks are interchangeable but they are not the same. LC has several different shocks based on year model and 3rd row seats and some other options. The LC shocks are considered to be more firm then the stock LX shocks.

Is there something tricky with the process?
Nothing really tricky and the time to swap shocks will depend on your experience, the equipment you have, and the condition of the bolts. If you don't have a rust problem then the only 2 that might cause you a problem are the lower rear bolts. Sometimes those bust even if the truck has never seen rust so be careful when you remove those 2.

You'll need TALL jack stands. I recommend at least 6 ton and preferably the 12 ton stands. You will need some way to lift the truck; obviously it will take a lot longer if you use the factory jack vs a good floor jack. Air tools make the job quicker but you can certainly do it with hand tools. Since this is your first time doing shocks on your 80, you should plan for 6 hours or maybe a little more. The DS front shock can be a challenge if you don't have the right tools.

-B-
 
Thanks for the heads up on the install.

I think I will go with 97 LC shocks, I really don't like the wabbliness of the LX.
 
Thanks for the heads up on the install.

I think I will go with 97 LC shocks, I really don't like the wabbliness of the LX.

If that is the case, you should look into a set of bilsteins which have far better dampening. You will find a lot of info if you search here on the bilsteins and their price is not much more than the OEM shocks.
 
Cary:

i thought i read a thread about aftermarket rear shocks getting distroyed by flying rocks generated from front wheels. So I don't want complications like that. Any thoughts on that?
 
Cary:

i thought i read a thread about aftermarket rear shocks getting distroyed by flying rocks generated from front wheels. So I don't want complications like that. Any thoughts on that?

I am unaware of that happening. Bilsteins offer the same protection as the stock shocks. I am unaware of anyone having failures of the Bilsteins, which are a higher quality shock than the factory replacements.
 
I have changed the shocks on the LC with OEM but it is a firm ride and u feel alot of the bumps on the road mine is my DD and sometimes i wish i went with the LX shocks, i guess is a trade of between stability and confort, replacing your old shocks with new LX ones might give you just the stiffness your looking for . As far as the install is a piece of cake, as long as u got the right tools in my case took 30 min with air tools might take a bit more with regular tools and spraying the bolts with liquid wrench before u work on them helps a lot.
 
Back
Top Bottom