Shimmy question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2006
Threads
7
Messages
12
Ok, I'm not trying to rehash an already covered topic but just wanted to know if i could narrow something down.

I have a pretty good shimmy at 60mph and above. Truck drives great. It's SOA with 35x12.5''. It has a shackle reversal.

I realize the shimmy could obviously be tire balance but i just wanted to know if the fact that the truck drives and tracks great while shimmying, points away from the SOA.

I realize all the culprits that could be causing this but just wanted to see if i could narrow it down a little by realizing that the truck doesnt wander and isnt darty at these speeds.

thanks
 
first things first. I would check this post by manny to make sure you toe is adjusted correctly

https://forum.ih8mud.com/showthread.php?t=45902

also, was your axle cut and turned when it was sprung over?

I had a few issues with a shimmy when I got my 40 and if it were to happen again, I would check your tire pressure too. mine had wayyyy to much which resulted in feeling like my cruiser was driving on marbles all the time. dont know what you got in there now, but take it down to ~20psi and see what happens. Might be a place to start.

lastly, my prev set of wheels may have been bent causing front driver to potato chip slightly and added to my shimmy. see if you can find someone near you that has a set you can take down the fwy and see what happens.

mike
 
Back
Top Bottom