Started work on FJ40 body. Cut out some rust out from inside front area on front fenders leaving 2 inch by 6 inch rectangle hole. Looking for recommendations for someone in the Springs area who could cut and weld in two patches. Thanks.
Sheet metal/patch panel recommendation in Co. Sprgs?
- Thread starter GJCruiser
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
I'm up in buena vista, but would be happy to do that depending on how much is needed to be done.
Do you have any pictures?
Do you have any pictures?