I have 2005 sequoia sR5 4wd, drivers side rear wheel bearing needs to be replaced
Cost: Toyota 1100
local shop 600
contemplating DIY- I've done a lot of researched how to do it.
To do this need to buy:
1. axle shaft puller OTC 095212501101 Rear Axle Shaft Puller for Toyota
2. OEM bearings and seals
3. Press from HF, around $200
I'm thinking DIY will save me $$$ in the future when the other side goes bad.
Any of you guys done this job before? difficulty level?
I'm not a mechanic but been doing knuckle job, suspension lift and some other stuff on my 1996 LC
Cost: Toyota 1100
local shop 600
contemplating DIY- I've done a lot of researched how to do it.
To do this need to buy:
1. axle shaft puller OTC 095212501101 Rear Axle Shaft Puller for Toyota
2. OEM bearings and seals
3. Press from HF, around $200
I'm thinking DIY will save me $$$ in the future when the other side goes bad.
Any of you guys done this job before? difficulty level?
I'm not a mechanic but been doing knuckle job, suspension lift and some other stuff on my 1996 LC