Saginaw: Can I remove this frame bracket?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 17, 2003
Threads
37
Messages
310
Location
Jacksonville, FL
Planning on Saginaw-type power steering. Do I need the frame member that supported the origianl steering box?

Looked at the FAQ's and other posts, and I'm pretty sure I do not need it, but I'd like some reassurance before I cut it off.

Been thinking about getting the Cruiser Solutions kit.
 
Last edited:
A tip

After you have removed the rivets that retain the pedestal, replace them with bolts to hold the frame halves together.

Many years ago, before I had the gumption to do such work myself, I paid a shop big bucks to do the power steering conversion. Several years of wheeling later, I noticed that all the rivets adjacent to these had popped, usually the inner head, and the frame sections were separating. Additionally, where the rivets hadn't popped, the frame had small cracks developing. I could actually move the frame haves 1/4" back together with my hand!

Had the 'professional' installer replaced the rivets with bolts, the addittional flex would not have occurred, which then wouldn't have overstressed the adjacent rivets, and so on.

I had 11 distinct crack in the frame to repair. Granted, some were also on the other side (I guess I wheel hard) :doh: but at least 4 were unique to the left side, adjacent to the formewr steering box pedestal.
 
Cool, will get it off. Thanks for the advice on filling with bolts.

Got plenty of experience getting frame rivets out since I had to take off my rear crossbraces. Angle grinder, cut off tool, drill, air hammer/chisel, torch and they are STILL a biaaatch to get out :-) But I'll get it done!
 
Back
Top Bottom