- Thread starter
- #61
DONE (basically)
Got the rest of Rusty's doors finished.
Just need him to see them and discuss a few points.
I re did the "corner" spot. I didnt cut it out, but re welded it to make it better and more even.
The top panel that I cut out a re did as well. It had gotten warped with heat. I got a little too confident on the 18ga material... so I re did that as well
K
Got the rest of Rusty's doors finished.
Just need him to see them and discuss a few points.
I re did the "corner" spot. I didnt cut it out, but re welded it to make it better and more even.
The top panel that I cut out a re did as well. It had gotten warped with heat. I got a little too confident on the 18ga material... so I re did that as well
K