Running a PS pump test, no hoses

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 9, 2005
Threads
271
Messages
5,828
Location
Cary, NC
Is it ok to fill 'er up w/ fluid and run w/ caps over the fittings to see if the pulleys are running smoothly?

Guy at the parts store said it would be ok, I wonder if it wouldn't blow fluid out of the plastic cap that came in the pressure output port.

Opinions?
 
mtweller said:
Is it ok to fill 'er up w/ fluid and run w/ caps over the fittings to see if the pulleys are running smoothly?

Guy at the parts store said it would be ok, I wonder if it wouldn't blow fluid out of the plastic cap that came in the pressure output port.

Opinions?

If the guy at the parts store is going to come over and clean up the mess then go for it.

The things make serious pressure. Run a line from output to intake.
 
You can try and route the pressure hose into the filler hole of the reservoir/can and put a piece of hose on the return tube and route it back to the filler hole also and try it, but I am not going to say that you might not make a mess doing this. I certainly would not take it over idle, read 650 RPM’s, as the oil will be flowing out the pressure line really well.

Wear safety glasses. :)




---OR----



Get it close, plumb it correctly and then run it.


If it needs adjustment, then take care of it then.....you should not have a problem getting the thing 'close'....


Good luck!


-Steve
 
Back
Top Bottom