RTH. Trail tailor winch bumper install

[silverhorse]

So I got the factory bumper off I'm trying to figure out what I'm supposed to do with the parking sensors that are in the top of the factory bumper. Could not find any info when searching

 

[silverhorse]

Okay so I think I got the parking sensors confused with the washer fluid things .. assume we have to block these off?

 

[indycole]

Okay so I think I got the parking sensors confused with the washer fluid things .. assume we have to block these off?

Yep, clamp those off. I think I put an M10 bolt in the tube and secured it with a hose clamp.

 

[silverhorse]

@indycole did anybody have to cut or trim the lower grille/radiator support metal piece?

 

[silverhorse]

Radiator support piece shown below

 

[silverhorse]

I also trimmed the air dam for the power steering cooler as per arb's instructions for their bumper install

 

[silverhorse]

I also capped off the water line going to the headlight washers with a stainless steel bolt and clamp

 

[silverhorse]

Also trim the air deflector on the left side of the vehicle

 

[silverhorse]

Got the bumper installed and just an FYI I used to xd9000 Warn winch which is kind of tall so I had to trim the radiator support bracket all the way up ...

 

[silverhorse]

If anyone is curious the bumper is line X'd with a factory gray tint to it .
I would not use it again. It adheres to itself so when it comes off it comes off in sheets and it started to do that already in a couple places .

 

[silverhorse]

Overall impression on the trail tailor bumper awesome! great welds! fit perfectly.. qualities top notch