RTH: starter removal...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 3, 2006
Threads
259
Messages
1,935
Location
Fort Apache: Victoria
So it looks like my starter solenoid has packed it in.

I have an FSM and it looks like there's one big-assed bolt that runs though the bell-housing flange and holds the starter in place. I've removed that bolt and I can't get the starter to budge. Is there another bolt or nut that I can't see?

RTH would be appreciated - I need to get this fixed today as I can't afford any downtime from work.
 
Unbolting the transmission dipstick tube and twisting it out of the way helps with space (it may even be necessary).

1) Disconnect battery
2) Remove the (2) wires connected to the starter (one has a clip the other is stud and nut)
3) Remove the (2) bolts that hold the starter
4) Pull the starter out

Riley
 
Last edited:
Is there another bolt or nut that I can't see?

There are 2 bolts, one from front to rear and the other goes into the bell housing from the rear to the front.

-B-
 
There are 2 bolts, one from front to rear and the other goes into the bell housing from the rear to the front.

-B-
2x.

And the small 3/8" air impact from Craftsman with 12" of extension can save you a lot of knuckle skin.

Be sure to inspect your PHH while you're in there.

(From doing same job on a '96)

YMMV
 
Found the second bolt right after I posted. Funny, it's not in the FSM. Anyway, even with both bolts out it was a PITA to get the starter unstuck - a few years' worth of leaky PS fluid seemed to fuse it to the block. A BFH eventually got it loose.

Turns out it has a broken shaft. Nice.
 
2x.

And the small 3/8" air impact from Craftsman with 12" of extension can save you a lot of knuckle skin.

Be sure to inspect your PHH while you're in there.

(From doing same job on a '96)

YMMV

For the record, I had no problem accessing the bolts with a medium wrench and 17mm deep sockets.
 
Deep sockets and wobblies are your friend! I will be doing this in the am. I am glad you got it out!
 
Back
Top Bottom