RTH!!!!HELP HELP Help With disc brake piston

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 25, 2009
Threads
176
Messages
3,575
Location
Richmond, VA
Started to replace pads and removed caliper to clean it.
Started to push in pistons and one of the pistons poppped almost all the way out and fluid went everywhere.
How do I get it back in I need to fix tonight.
Thanks
 
Is the piston hanging up in the bore? Is it bound up on the seal? Might be best to just pull it the rest of the way out (carefully) and take a look. It might need some lube, but should go right back in if there's nothing in the way.
 
Thanks bro,
It finally went back in after I took it all the way out.
But it still gave me a hard time going back in but it went.
I lost alot of brake fluid.
Off to Wal-mart to get more now to button this up.
Thanks again.:bounce::bounce::bounce::bounce:
 
The boot probably jumped out of the seal ring. You need to get the boot seated and the piston will slide right in. The fsm has the proceedures. Might be a good time to buy a caliper rebuild kit.

:cheers:
 
I am good with a wrench but you know when something goes not as planned and you freakout.:idea:
That is what happened.
It is all good just got back from bedding in the new pads.
Works like a champ.
A caliper rebuild kit is definitely in the near future, the boots look a little shot.
Brakes work good and that is all I care about because I am going wheeln this weekend!:steer::steer::steer:
Thanks for the replies guys.
 
Back
Top Bottom