Rotten tub..

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 16, 2004
Threads
45
Messages
185
Right where the centre body mounts are on my LC, they look like they are ready to fall apart. Very punky looking.. Does anyone have any suggestions on how to rebuild this part of the tub? I am getting new quarter panels,wheel wells and rear deck from canadacruisers.. I want to fix this tub up right.. Does anyone have any suggestions on how to rebuild that part of the tub?
 
Square wall tube is a common fix but dunno about 4" I thought it was smaller but I could very eaisly be wrong. Dunno if your set on a steel tub but why not go with an alternative repro? I welded up the majority of my tub and regret every frickin wasted min since there was no way to get it rust free/proof without replacing just about every panel. I seriously hope my repairs rust off in 5 years so I can rationalize the time savings a gozzard or aquala install. But if you're doin the whole thing than I can see the obvious reasons for going steel.
 
I just used 4x3 on mine, it fit fine. If I were to do it again, I think I would try 4x4. I also made it my air tank.
 
Now this is a rotten tub!
img017.webp
 
Big B. said:
Now this is a rotten tub!
NO MOMMY MAKE IT STOP *hides in corner* ok what he seems to be talking about is the rear sill and 2 pieces of 2x2 angle iron welded just right fixes it (cause you need to also weld in the new body mounts if you're talking about what I think you are but i think 4" squares would probably work too if you put in the body mounts.:cheers:
 
Back
Top Bottom