Roof Rack

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2006
Threads
101
Messages
513
Location
Alpharetta GA
Finally broke down and removed my roof rack so I could fit it in the garage. With one eye closed I still saw a good bit of rust right around the holes :doh:. Anyway more concerned with plugging the holes now. Should I just source some shorter bolts and put a little silicone around them to seal it up? I do plan on reinstalling the rack eventually when a little more weight is applied to my cruiser to bring it down an inch. Shameless as it is I tried that excuse with my wife to convince her to fit it in the garage but it didn't work. No sliders and rear bumper still for a while.:crybaby: Too lazy to search, let me know what everyone else is doing for a solution. :cheers:
 
I did what you're proposing - silicone on some new short bolts.

If you search you'll find many reasons to replace that factory rack with one that mounts on the gutters as well as a slue of information on options to seal up the holes from weld over, tape over to bolt options, use silicone, don't use silicone, paint, Line-x, etc. etc.

Basically there are a lot of options out there, just depends on how much you want to spend/do and how you want it to look. The silicone and bolts has worked for me for nearly a year now but I do plan to give it a cleaner look at some time.
 
Back
Top Bottom