Rocking after a stop

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 21, 2015
Threads
48
Messages
1,080
Location
FL
Driving me mildly crazy, but after coming to a full stop the truck rocks a few times front to back.

The amount of nose dive doesn't seem excessive; the AHC system works fine & pressures normal. No unusual noises on deceleration or acceleration. While driving there is no degradation in ride that I have been able to detect (probably there, just degraded slowly enough I didn't see it coming).

I'm guessing some bushings are weak and rocking is the result.

Asking if those who know suspension systems, and those who have done a fair amount of bushing replacements, where I should start looking to bring the system back into normal.
 
Edit: I somehow missed where you said your pressures were normal. Good luck finding the culprit.

Have you checked your AHC neutral pressures?

My rear pressures are pretty high due to too much lift for the springs I have in the rear. I experience some tilting when stopping, the rear come up and has to readjust. When I accelerate the rear drops and has to readjust.

I wouldn't really call mine rocking though as it doesn't go back and forth like you're describing.
 
Mine doesn't rock but definitely moves after I put it in park.


Your're probably referring to the PAWL. All vehicles will move some when you put them in park. If you put it in Neutral then E-brake then let your foot off the brake before putting in park you will put the majority of the load on the brake not the PAWL.



pawl_in_notin_park.png
 
Have you added front or rear bumpers? They can add a lot of weight WAY out there creating a cantilever effect and cause some see-sawing when coming to a its top. It's more common with SWB vehicles like 40's but I noticed some when I added my ARB and winch up front.
 
Minor update: Tried different settings on the comfort/sport setting and there is a difference rolling down the road, but I honesty can't tell if there is a difference in the rocking motion immediately following a full stop. Regarding AHC: normal pressures, around 11 graduations between low and normal, suspension feels more compliant & smoother riding than the Prius or FJ I have most recent experience driving.

Maybe I should clarify - at a sort of normal stop sign stop & go it isn't noticeable, and in coming to a smooth stop for a light it can barely be felt (or not at all if I'm extra smooth in stopping). Where this is most pronounced is when moving in a stop and go traffic situation. Gets the normal (small) amount of nose dive, then rocks back and forth around 4 times before the rocking motion is too low to feel.

No other unusual traits being exhibited - but this small rocking motion when stopped is nothing like any other Toyota/Lexus I've owned (Tacoma, 4 Runner, FJ Cruiser, Prius, Camry, ES300, MR2).
 
You ever sort this out? my new to me 2004 LX470 does this as well. The rocking isn't jarring or uncomfortable, just seems weird. Never owned an LX or LC so wasn't sure this was normal or not....
 
Where this is most pronounced is when moving in a stop and go traffic situation. Gets the normal (small) amount of nose dive, then rocks back and forth around 4 times before the rocking motion is too low to feel.

IMHO this is a damper issue, worn out shocks or under sprung/over loaded land cruiser. How it relates with AHC I couldn't say. If I had AHC and the front to rear pitch was bad I would remove a front shock and inspect. If it falls on its own I would replace both. Since they are cheap I'd buy and replace both anyway if I was uncertain about age.
I don't believe springs and TB's wear out just because they are old.
 
Last edited:
IMHO this is a damper issue, worn out shocks or under sprung/over loaded land cruiser. How it relates with AHC I couldn't say. If I had AHC and the front to rear pitch was bad I would remove a front shock and inspect. If it falls on its own I would replace both. Since they are cheap I'd buy and replace both anyway if I was uncertain about age.
I don't believe springs and TB's wear out just because they are old.

I would normally think this too -- if it didn't have AHC I would even bet money you are correct. However, for the AHC system it doesn't seem so obvious - to my limited understanding anyway.

1. Truck exhibits this when unloaded, just me in the truck.
2. As I understand AHC the "dampers" are essentially hydraulic pistons with the damping occurring at the globes - and from what I read, when they start to fail the suspension becomes harder. Would love to hear from others that the aging globes exhibit this same issue - would answer my question.
3. AHC damper and/or globes = Not cheap
 
I would normally think this too -- if it didn't have AHC I would even bet money you are correct. However, for the AHC system it doesn't seem so obvious - to my limited understanding anyway.

1. Truck exhibits this when unloaded, just me in the truck.
2. As I understand AHC the "dampers" are essentially hydraulic pistons with the damping occurring at the globes - and from what I read, when they start to fail the suspension becomes harder. Would love to hear from others that the aging globes exhibit this same issue - would answer my question.
3. AHC damper and/or globes = Not cheap
How worn are your "shock" bushings?
 
How worn are your "shock" bushings?

Worn and I have a set to replace them with when I get some time. Meanwhile the movement seems more than the bushing diameter - but once it starts moving maybe the weight shifting contributes, etc.
 
Worn and I have a set to replace them with when I get some time. Meanwhile the movement seems more than the bushing diameter - but once it starts moving maybe the weight shifting contributes, etc.
Worn top/bottom bushings can contribute to a lot of motion.
 
I would describe mine as more of a shock wave that moves front to back several times if I stop abruptly. I can get it to do it if I'm at a stop, let of the brake to barely roll fwd then stab the brakes, you can feel it go from front to back 2 or 3 times fading away.

Any physical movement of the nose or tail is not visibly noticeable.
 
I would describe mine as more of a shock wave that moves front to back several times if I stop abruptly. I can get it to do it if I'm at a stop, let of the brake to barely roll fwd then stab the brakes, you can feel it go from front to back 2 or 3 times fading away.

Any physical movement of the nose or tail is not visibly noticeable.

That's actually a better description than I gave -- I think we have the exact same problem. I jacked up my front end and was doing an old school ball joint check when I noticed the lower A-arm moved some before the "shock". Hence why I ordered in some bushings. Given my current work circumstances, it could easily be months before I can pull off enough to do the bushing replacement job. Good luck to you and if you can confirm cause I am "all ears".
 
Back
Top Bottom