Rocker panel question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 28, 2004
Threads
55
Messages
179
Location
Philadelphia, PA
I need to replace part of the panel right below the door. Can any body tell me what is involved getting it off? I have never done it and I know with most jobs on the FJ once you start something more complications ensue.
Is is bolted on or welded? besides the step, what else will I need to take apart to be able to get it off. any help muchas gracias
 
In stead of replacing my entire rocker panel i chose to cut out the bad part and just weld in a new panel of metal i got from the local metal shop. Post a pic as to how bad it is and someone should be able to tell you.

HTH
 
Just how much of it needs replacing? The door sealing surface and all, or just the flat part below that? If it's just the flat part you should be able to cut it out fairly easily, and if I remember correctly it has flanges that are welded at each end of it. Just take a good look at it, get whatever materials you're going to use and get to cuttin. Oh, and post up pics along the way.

Here's a thread with some of it. https://forum.ih8mud.com/showthread.php?t=36515&highlight=rocker+panel

But this one seems to have exactly what you're looking for. https://forum.ih8mud.com/showthread.php?t=41643&highlight=rocker+panel

May get more results with a quick search. :beer:
 
Last edited:
The flat part below the door is where the problem is . But I know doodly squat about welding, so I will look for a local welder who can help.
 
The flat part can be easily fabricated using sheet metal (18 gauge?) and bending the flanges between two sheets of 1/4 steel with a body hammer.

As far as the welding goes, the average guy turning out steel hand rails and structural items may have a hard time butt welding 18 ga. without turning it into mess from all of the distortion. It's not brain surgery, but it is an aquired skill and it takes patience. You may want to get someone familiar with welding rusty old car bodies to do it.

Plus while you're at it you will want to paint all the inside stuff with epoxy primer, seal the seams with seam sealer, then squirt inside the cavity with someting like 3m rustfighter.

Nothing real hard about any of this, but there are quite a few steps involved.
 
Rocker Panel fix

I cut out the rusted metal, found an old shelving unit made of 18 gauge steel from which I cut out the new piece and spot welded it in place....
DSC02275.webp
DSC02286.webp
DSC02294.webp
 
Back
Top Bottom