Rhino Line Remover (8 Viewers)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I removed "Rhino" liner from the 40 a few months ago, razor knife, get an edge and pull it off in sheets with pliers. peice of cake. enjoy
 
I love Line-X on the floor of my tub. I can spill anything (brake fluid included) and hose out the tub. The brake fluid left just a slight discoloration. All liners are not the same. The PO of my FJ had the Line-X put in the tub properly. The underside of the rig was "powder-coated" with what looked like plastic goo. That crap pealed right off. It looked like little or no surface prep was done before application. Line-X was removed from the tranny cover with a lot of sanding and grinding.

Line-X is used and tested by the military for various applications ranging from non-skid flooring in subs to "polymer armor".
 
whatever happened to just painting your s*** and keepin it clean. Fawk lining.
Poser , answer to post #14 , THC , and shrooms don't fawk with your skin either.
Once again , fawk all the liners. Waste of time.
 
i'm grateful to read these replies. i think heat would probably work best for me, as i'm hoping to preserve the pearl white underneath. am i the only one who thinks a rhino liner two tone is an awful look? i've always thought it was just what you do to hide rust. no rust on the frame or under floor though. smh rhino liner
 

Users who are viewing this thread

Back
Top Bottom