reverse lighting switch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 18, 2007
Threads
13
Messages
41
hey i did some searching and i found that the switch for the reverse lighting is located on the back of the tranny. will that be the case for my 76? and is there any easy way to get to this with the car assembled? i have no power to my lights and am trouble shooting.
 
Yes, your truck will be the same. The two wires for the switch run across the back of the transfer case (along the rear edge of the Hi-Lo shift cover) to the passenger-side frame rail. You can disconnect them there (bullet connectors) and test the switch.
 
If your Cruiser is anything like mine, you should have an abundance of wire ends under the dash and in the engine compartment. Just find a hot wire with a tester light and use that. I found a hot wire located near my washer fluid bottle and ran it back to the reverse switch. It has worked great for several months now.


anyone know where a ignition switched hot wire is, thats located up front?
 
Back
Top Bottom