Reverse light switch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Colorado Boy-74-FJ40

I may grow older but I refuse to grow up!
Joined
Aug 5, 2005
Threads
83
Messages
1,461
Location
Windsor Colorado
I'm blowing the fuse that controls the gauge cluster. I looked at the diagram and it appears it is the backup light switch. I confirmed this by putting the stick in reverse and the amp gauge dropps to full negative and after about 4 seconds the cluster fuse blows. What I'd like to know please, is where is the backup light switch assembly so I can check it's operation/malfunction and trace the wires back to the taillight assemblies to look for a short or run new wires. Thanks
 
I found the switch. It is pretty straight forward in operation. A power wire (red) and a wire that is hot after the switch is made ( Red & Purple) I wrang out the wires to the tail light assemblies and didn't find any short-to-grounds then I put the meter on the red & purple wire and had my kid hit reverse, I had voltage, then the fuse blew. I know somewhere in the system I have a short to ground upstream of the taillight run (switch side). Maybe it's the switch itself or the power (red) wire. I think if it were the red wire it would blow the fuse regardless of the switch actuation unless the switch engagement is the straw that breaks the wiring run's back. Any feedback would be appreciated in case I'm too close to the forrest to see the trees
 
Try this...disconnect both wires going to the reverse light switch. Put your amp meeter in series and then check to see if you get the amperage spike. If you don't, this will tell you that your switch needs replacement.

Good luck!
 
Back
Top Bottom