reverse idle gear shaft

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 20, 2005
Threads
29
Messages
93
i got a little excited when i finished the parking brake, and pulled out the reverse idle gear shaft instead of the filler plug. now i'm nervous because it doesn't go back in. it goes within an inch of all the way then hits its intended destination. When i look in there i can see whats happening, but there is no way to leverage it up and back. How bad did i just screw the pooch.:doh: 1970 fj55
 
Are you talking about the transfer case? If so, it's not a "reverse idler shaft". It is just an "idler shaft". If it's the transfer case that you're talking about, then you probably have a situation where the front thrust washer has slipped down and is not allowing the shaft to pass through.
You *should* be able to reach inside and reposition the washer. If not, then you will probably need to get the PTO cover off and also get the top cover off to get in there and put things back straight.


Mark...
 
i saw the thrust washer, and was able to keep it in line. the whole package in there gradually dips from flush at the washer to about an 1/8 inch sag. the shaft is about 5 inches, smooth, with a built in o ring. i can get all the rollers in but can't get it up and into the housing.
 
What does this intail. is the power take off on the driver side, and the top cover is accessible from the cab. then just a matter of coordinating the parts. any pointers.
 
Back
Top Bottom