Replacing chassis rivets

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 21, 2006
Threads
21
Messages
369
Location
Stanthorpe area, QLD, OZ
Wondering what people have used to replace the chassis rivets. I'm putting ideas together for a rear bumper and thinking about replacing the rear cross member and incorporating the new bumper into the chassis. To do this I would have to drill out the old rivets and replace them with something.

What have others used and if bolts are the only option then whats the best way to make sure they are as secure and as strong as the factory rivets?

Thanks:)
 
When I swapped out my frame on my 74 I got a replacement frame from a 72 so I changed the rear cross member to keep the tail lights stock. I used carriage bolts to replace all the rivets on the rear cross member. I was told you can't get grade 8 carriage bolts so I got grade 5 carriage bolts which were the highest grade I could order. The carriage bolts look just like the rivets and I rewelded the spring hangers.
Frame.webp
 
I used cap bolts grade 8, the heads shaped same as the original rivets. then I put a little bondo in the allen heads. then paint and the face looks original. on the other side of course the nuts and lock washers.
 
What size of cariage bolt was use? Diameter and length. I would like to pick some up on my way home so I can paint my frame tonight, any help would be greatly appreciated.

Thanks
Scott
 
Portal_tek said:
What size of cariage bolt was use? Diameter and length. I would like to pick some up on my way home so I can paint my frame tonight, any help would be greatly appreciated.

Thanks
Scott


IIRC they were 3/8 x 1 1/4 but you might want to measure your holes.
You have to round down the square part of the bolt under the head so it will fit flush.


Kevin
 
Back
Top Bottom