Replacement Saginaw Box Bolts???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 16, 2004
Threads
49
Messages
413
Location
Seattle
Website
www.seattlecruiserheads.com
I have a three bolt Saginaw PS conversion on my 78 FJ40. While on a trail run the front end got smacked pretty good. The Saginaw box bolts sheered off. I do not have the cash for a hi-steer system right now. I have made a ghetto-fab steering box brace that sits between the frame rails. Looking back I wish I had narrowed my search to a four bolt box when doing the PS install.

My concern is with the box bolts themselves. I think some of the internal bolt threads within the box have been damaged. I am looking for the best bolts & possible locking nuts to replace the sheered bolts. What should l look for? Looking for specific grade, bolt size, thread count etc.

Thanks!

Max
 
Grade 8, 7/16-14 NC, and compatible grade 8 metal locking nuts. I am partial to Caterpillar hardware.


The length of the fastener will need to be determined by your specific application, as there are many variables that can enter into the mounting of the steering gear, since there are more than a few ways to mount the gear to the frame. Something else to consider is the room for the lock nut on the other side of the mounting ear.


You will also need to look at the ears on the gear and make sure that they have not cracked, which is not uncommon in situations like this, or you will be right back where you currently are.


In the end, steering gears are cheap, and replacing it with a new remanufactured unit that has four mounting bolts, and then creating a solid brace from the gear to the passenger side frame rail would be a good idea right about now. There have been many part numbers listed out here for quality four bolt remanufactured power steering gears.



Good luck!


-Steve
 
Steve,
U DA MAN!!!

This is just the info I was looking for. Great advice as well. In the end I may do as you suggest. Right now I have a mixed set of "trail emergency" bolts holding the box in place. My thought was to first purchase a set of quality bolts and then drop the box to see where I am at. At the very least a fresh set will improve safety for street driving. The combination of these grade 8 bolts and the completed steering box brace may be fine for the trail as well. Or, I may have to replace the box and go from there. Right now the box's steering functionality is just fine though.

Thanks!

Max
 
Back
Top Bottom