Replaced O2's (pics)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 21, 2004
Threads
129
Messages
1,575
Location
MN physically, MI spiritually
Which one looks bad to you guys? The one on the left was the outboard (#2) and the other was the inboard O2. The cel code said #2 was bad. I take that to be the one on the left?

Kroil worked wonders sept on the littlest nut which was a 1/2 hour of small vice grips. Truck runs much smoooooother now and the exhaust smells much "better". If better is the correct word.

Rotor, cap and plugs as well. Thanks Dan! Please call off the pooches now.;)
 
Last edited:
On a 91-92 (actually 88-92) with the 3FE motor, they're parallel: one on the downpipe for cylinders 1 thru 3, the other on the downpipe for cylinders 4 thru 6.

I *thought* this was also the case for 93-94 1FZFE's, since those are also/still OBD1.

Maybe I'm wrong; can someone verify one way or the other?

Curtis
91FJ80
 
There are two down pipes on the 93/94 attached to the two cats side by side. Both O2's are pre cat at "hard to reach that one bolt" angles.

Ok, that's what I thought

The rear three cyls are on the inboard side (#1 cat).

So here's where I still have a question: I really thought the sensor/cat. for the first three cylinders (i.e., the "outboard" one) was the one called "#1". No? Where are you getting this information, I'd be curious to look. (Admittedly, I don't have any reference for my thinking; I'm just going by (poor) memory.)

Curtis
 
CJF...you are correct my 93 has both sensors pre-cat.
one on the front three holes, one on the back three holes.

Although the OBD II CEL codes say pre and post cat sensors they are actually both infront of the cat.

This also leads to a very confusing time sourcing out sensors for 93-94 model years. The sensors both sit in front of the cat but they have different OEM part numbers (the way I understand it they are sampling for diff. gases and or tricking the ECU that at the time of production was also on the verge of being upgraded)

So take my advice.........Just call Cdan.
 
So here's where I still have a question: I really thought the sensor/cat. for the first three cylinders (i.e., the "outboard" one) was the one called "#1". No? Where are you getting this information, I'd be curious to look. (Admittedly, I don't have any reference for my thinking; I'm just going by (poor) memory.)

Curtis

You could be right, I just assumed that things start in the center and work out so I call the inboard sensor the #1. But it does make sense that the first three cyls dump into #1 which is the outboard.

Questions like this are why I replaced them both. I'm not really positive and I hate to search the archives unless I really have to!:o
 
You could be right, I just assumed that things start in the center and work out so I call the inboard sensor the #1. But it does make sense that the first three cyls dump into #1 which is the outboard.

Questions like this are why I replaced them both. I'm not really positive and I hate to search the archives unless I really have to!:o

I like searching when I'm bored. :D

x2 on replacing both. Replacing one seems to me like pulling your spark plugs, deciding two of them still look ok, and therefore just replacing the other four. :lol:

Cheers,

Curtis

P.S. Let us know if your mileage changes now...
 
Back
Top Bottom