Removing the Catalytic Converters

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 1, 2008
Threads
24
Messages
311
I'm moving to Africa (Ethiopia) and need to remove the cats due to leaded fuel. I'm thinking I may go the Magnaflow route except add flanges so I can unbolt and replace as needed. This way, I can run the stock cats until they die, then swap in the Magnaflow. It's just a 2 year gig so hopefully I can get a year out of each one.The reason I want to go this route is to avoid the CEL and any possible lean/engine management issues.

Thoughts? Previous experience?
 
Check into a replacement Monolithic Converter. I'm told they work about the same as a Cat Conv. at slower city speeds, and work better than a Cat. at faster highway speeds. I doubt that leaded fuel will destroy a Monolithic, but check that out with the manufacturers???
 
Sorry for the lack of info, I thought it was included for some reason. Anyway, this is a '96 OBDII so unfortunately, I have sensors to worry about. I'll take a look at the Monolithic though, I hadn't heard of that one.
 
Back
Top Bottom