Been a while since I've posted here, but figured I'd ask the forum before I wasted too much time sourcing and figuring it all out (probably twice) to get it done.
My factory front bumper has about had it, and last year on a trip up to crown king I folded it back enough to catch the ad canister and break the lines going to it. I'd like to relocate it up behind the battery similar to the way AZ4ME did in a post.
Does anyone have an older cruiser ad hard line set and dryer lying around they are willing to part with? I know people that will braze it for me, so just looking for parts.
Or 2, have a better way to do it?
I finally got a winch for the cruiser this last year while at 'king of the hammers' so I figure I ought to fix the ac when I pull the old bumper off and start building a new one.
Any advice is appreciated.
My factory front bumper has about had it, and last year on a trip up to crown king I folded it back enough to catch the ad canister and break the lines going to it. I'd like to relocate it up behind the battery similar to the way AZ4ME did in a post.
Does anyone have an older cruiser ad hard line set and dryer lying around they are willing to part with? I know people that will braze it for me, so just looking for parts.
Or 2, have a better way to do it?
I finally got a winch for the cruiser this last year while at 'king of the hammers' so I figure I ought to fix the ac when I pull the old bumper off and start building a new one.
Any advice is appreciated.