redoing door panels

[tbk125]

so whats the best way, iv heard to use marine board because it wont get the warped wave appearence over time, where do i get those metal tabs and good vynal cloth

 

[cruiser_guy]

Before tearing off the old vinyl or tossing the old panels if the drivers side is any good and matches this:

https://forum.ih8mud.com/fj55-iron-...otm-cruiser-guy-guatemala-12.html#post5889750

https://forum.ih8mud.com/fj55-class...side-panel-needed-make-my-interior-100-a.html

let me know. I've been looking for one for a while.


As for the question, I think the original hardboard is fine IF the plastic sheet vapor barrier in the door is installed correctly and not full of holes.

 

[bobm]

I am going to make mine out of aluminum.

Bob

 

[40Flipper]

Plywood, vinyl, hex-head screws and glue

 

[tbk125]

awesome thank you for the replys...

 

[htownfire]

Did you buy this rig from a firefighter from houston tx? If you did this the vary rig that got me into 55's