Rear wiper motor binding

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 20, 2007
Threads
115
Messages
593
Location
Provo, Utah
My rear wiper never worked on my '91, and today I figured I'd see what I could do about fixing it. I took everything apart back there and hooked the motor up to power. It moves slightly and binds. Reverse polarity and it moves the other direction ever so slightly and binds. The plug is getting power from the switch. I pulled the motor out and hooked it up to 12V and it rotates just fine with no binding. Any ideas what could be causing this? I found a few pictures and it looks like mine is installed correctly. There's kinda only one way it can fit in there. Any help would be greatly appreciated. At this point I am considering a rear wiper delete, but I think I would regret that come winter time.
 
INSPECT REAR WIPER RELAY CONTINUITY(a)Check that there is no continuity between terminals 1 and3.(b)Check that there is continuity between terminals 2 and 3.If continuity is not as specified, replace the relay.

upload_2015-10-1_18-55-42.webp
 
Following up with this in case anyone else has a problem. The shaft the wiper arm attaches to had seized inside the bushing it rotates in. I disassembled the part (little circlip holds it all together) and, with generous use of penetrating oil I got it to move freely again. I lightly greased the shaft and reassembled everything and it works great now.
 
Back
Top Bottom