rear heater ground????

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 11, 2004
Threads
182
Messages
2,250
Location
Kansas!
what is the best way to provide a ground for the rear heater?....i hooked everything up....turned on the switch..nothing...took it apart touched the body against the seat frame and it worked....now what would be the best way to provide a permanent ground?
thanks
osagecruiser
 
Marc, presumably, you have battery to engine ground, so run an engine to frame ground with a braided strap and you can also run a frame to body ground using strap. But when in doubt, run another ground.
Guess that about covers it. That's what they do at Empoia State at least;)

Ed
 
Well, at least I got "SMART asshat." Ground is ground. Battery grounds to engine only. Your engine is cushioned with rubber in the mounts. Does not hurt to run a strap from engine to frame. Your body is also somewhat isolated(depending on the condition of your body mounts) from the frame. It just never is overkill to ground everything together. Most of the wiring problems I have encountered with vehicles and/or trailers had to do with a poor ground.


Asshat......? .........I'll remember that.;)



Ed:flipoff2:
 
TeeeeeeHeeeeeee:D
No offense taken. You can't offend me, we were almost not related once by marriage.:D
The ground thing is really important and grounding batt>fram>body is to me easier than running a separate ground wire for everything.

GL

Ed
 
I agree with degnol...

I have experienced loads of electrical 'gremlins' while working on the PIG. Once I added another strap to tie motor / bat / body to frame, several of those issues went away. I have also found that we connecting any grounds, it helps to get bare metal to metal. When doing this, I use a little dielectric grease between those connections.

When I put my rear heater back in, I grounded it to one of the mouting bolts that go through the body.

Chuck
 
You might try steelwooling the heater and body were they touch. Unless you have a fiberglass tub then your going to need a ground wire.
 
ok fellas...where exactly does this strap install?....i have searched and know that i can get them at the autoparts store.....but tell me the best spot for this dude...yota..i see in your sig line your in va...are you near james madison u?...my son will be attending a baseball camp there this summer....thanks

osagecruiser
 
Marc, you can go anywhere on the engine to anywhere on the frame......like from one of the engine mount bolts(that go into the block) to the closest bolt on the frame. Use star washers for a good grind in to the metal. Same deal from frame to body. Just a place where it is close, so you don't need an 18" strap.
The dielectric grease suggestion is a good one. It does not have to be one of the braided straps, you can use just a short battery cable. I have also seen smaller versions of the braided strap. Hopefully, you won't be carrying a lot of amps through the frame or body, eh.;)

Ed
 
yes Ground that hog.
I must tell you from dealing with british carfs and motorcycles(Lucas "the prince of darkness")

Oh and by the way, We have some great trail riding here in VA. While I live in MD. I work and Play in VA and PA. We had a Land Cruiser swap meet last fall at JMU. Contact Capital Land Cruiser's before you come into town and see if you can meet up for a trail ride.
 
Back
Top Bottom