Rear Heater bypass

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 28, 2006
Threads
12
Messages
73
Location
Calgary
Website
www.speedracer.ca
I've been reading a lot on the forum.
o Basically remove the 2 lines (pretty much take out the 2 T lines)
- ~ 5/8 (16mm) hose
o Blow out extra coolant out + cap the lines so crap doens't go through it.

https://forum.ih8mud.com/80-series-tech/286209-need-pics-rear-heater-bypass-firewall.html
https://forum.ih8mud.com/80-series-tech/216813-bypassing-rear-heater-hoses.html

But I was wondering based on:
ExpeditionLCMajorcoolingoverhaul

On the Diagram:
http://www.brian894x4.com/images/FZJ80coolingprojectx019.jpg

(1)
If I was to put valves on both sides (part number: 87209B) of the rear heater pipes - any caveats to this idea?

(2)
Anyone just replace the lines with braided material using the rusted lines as a tie down? Any reason not to go this method?
 
Last edited:
After looking at this in the day light and comparing pictures (I'll post soon) it's not as bad as the ones seen but will prob be like that soon enough. I see a lot of rust on the lines. The damage right now is the hose underneath the exhaust shield that is stating to tear or the line is rusting at the connection.

Good thing this is summer I drove it home without much worry other than leaving a small pool of coolant on the local supermarket.

I'm still thinking in replacing the lines with SS lines making life I hope easier in replacing than snaking tubes. It looks like the same un factor in replacing the PHH. The additional problem would be that I replaced the cat and welded a straight pipe.

The question is for the exhaust shield underneath the where the cat would be it looks to be only 4 10mm nuts that hold it in place. Is there anything else I would need to unbolt?
 
You will need to remove at least one of the cats to slide the shield off. Just buy new cat gaskets and bolts first as the gaskets will be shot and you will have to torch or sawzall the bolts to get them off.
 
Back
Top Bottom