Rear Hatch supports ? Help me !!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 10, 2005
Threads
3
Messages
9
Location
Ooltewah , TN
Does anyone know where I can purchase those Plastic Nylon bushings on rear hatch struts/supports..I checked w/ SOR.com and they donnt have them and I've checked with local Toyota dealer and they just laughed at and I'm sure htere are a few of you out there that are doing the same...:doh: but since Im a rookie at this , is there someone that could possibly help me out here...?? here is a lil description of them ...the are on the inside of the adjusting nut so that when you extend the shaft out of the base then you tighten the nut down and it squeezes the shaft so that it stays in place ....any questions ?please feel free to comment on this ...thanks
 
This outfit (http://www.motorcare.com.au/) was able to source several hard-to-find parts for me many years ago. For example, he found me a driver's side wing window seal for my '73. It was pretty expensive but 4/5 years ago, there were no alternatives. Have not bought anything from him recently, though.

If you're a functionalist rather than a purist, you can replace the struts with universals from your local parts store.
 
How about dumping the crappy HTML font?
It's blurry and looks like sheat. People will just ignore you rather than deal with reading that crap.

Oh, I replaced the hatch struts on my '65 with NAPA bought gas struts. Even painted them to match the red. Nice because you don't have to screw around with tightening the nuts - the struts hold the hatch up just like on a Mazda GLC.
 
This may be of help to thoses that dont have a clue as to what Im talking about ...they go insde the struts and on the insde of the adjusting nut ...it seems like a very inexpensive part but very hard to find ...
bushing1.5.webp
bushing2.webp
 
Take it to any machine shop and have them make you some. That part would take about 45 min. to make! easy money. Make sure you bring the better of the two so they can take some measurements off it. If you can get some nyon material and bring it.(McMaster-Carr)..That'll make things easier as well. (depends on the shop and what they make... they might not have nylon on hand)

Hell, have them make a bunch, and you can sell them afterwards!!!!
 
Last edited:
honk said:
Oh, I replaced the hatch struts on my '65 with NAPA bought gas struts. Even painted them to match the red. Nice because you don't have to screw around with tightening the nuts - the struts hold the hatch up just like on a Mazda GLC.


Unless you are doing a resto, I would do what Honk did. I'll bet the rattle factor diminishes, too. All you need is for that hatch to bonk you in the noggin one time.:doh:

Ed
 
ditto to degnol re: the bonk on the head!

ditto to YZFtaco re: make a bunch and sell 'em, if you go the machine shop route, most of what you're paying for is setup anyway, at least make get a few for personal consumption

but probably if you posted in the wanted to buy section, you'd find a set of the complete OEM struts that someone took off after the aforementioned bonk on the head

and thanks for changing the font
 
Back
Top Bottom