Rear Disk Brakes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 10, 2005
Threads
39
Messages
161
Location
New Jersey
Been researching alot about rear brake kits.
Found that getting most of the parts local not worth the trouble and local shops won't machine the rotors (afraid of liability).
TSM seems to be the choice.
Has anyone used them or is there a better choice.
I have a 76 FJ. :) with aussie lockers and 33's

Thanks
 
I put together my setup for $143. That was complete. Could do it for less now because the brackets now show up on ebay quite a bit. Just my .02 I would invest the rest in a rear locker.

EdIt:

missed the part about the lockers, D'uh.
 
Rotors

Where did you get the rotors and who machined the center.
That seems to be my problem.
Can buy them but can not get them machined.
 
Where are you located? Try to find a retired machinist or someone with a lathe who works on other brand vehicles - a smaller shop in a close by smaller town may be the answer.

Napa rotors - part number in tech section

I used AA Mfg weld on small chevy caliper brackets - $12 bucks total

I would drop the coin on Downey style stainless lines all around - check your local speed shop or bite the bullet and call Downey. By the time you source long banjo bolts and Raybestos conversion hoses you are almost halfway to stainless braided.
 
the guy that did my rotors hands out his bus. card. It says "An Indian w/ a lathe" Cool guy working parttime out of his garage. Charged me like 10 to do both.
 
Located in North Jersey near NYC and to many **** lawyers.
Went to 3 machine shop and 7 parts stores.
Even a couple of engine shops.

There should be a cheaper way than spending $500 bucks on a complete kit.
 
A machine shop won't do it? How do they stay in business?

Personally I don't think RDB on my 40 was worth it. Unless you have a few siezed pistons and the drums don't work but otherwise my drums were much more powerful and I have a adjustable p valve on it too.
 
wesintl said:
A machine shop won't do it? How do they stay in business?

Personally I don't think RDB on my 40 was worth it. Unless you have a few siezed pistons and the drums don't work but otherwise my drums were much more powerful and I have a adjustable p valve on it too.

Well both sides are leaking brake fluid, so I figured now was a good time to do it. The are really strong. Lock up in a hard stop.
 
i got my brackets, rotors and master cylinder from JT Outfitters. i dont remember how much but there master cylinder is for 4/wheel disc brakes so no proportioning valve needed. got the rear stainless lines that go from the T to the calipers from TSM ($50.00) and got the stainless lines for front calipers and frame to the T fitting front and rear from man-a-fre ($100.00) i thought this was a good mod in my opinion no more adjusting brakes or leaks. good luck!
 
I have a writeup on my webpage (see signature) about the rear disk swap. I sold over 100 sets of the brackets. I do not sell then now. JT took over that task. I would get the rotors turned by a friend that would charge $30 a set. If you weren't so far away, shipping a set for turning would be doable.
 
Back
Top Bottom