rear brake problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 11, 2007
Threads
70
Messages
1,693
Location
Burlington NC
I replaced my rear rotors, calipers, shoes, and pads. When i went to bleed them, there was no fluid getting to them. Theres no fluid at all.. Anyone had this problem? Or have any idea what could be causing it? Front brakes are working great... but wearing fast due to there being no rear braking force.:bang:

could it be a bad proportioning valve?
 
wow, if thats all my problem is, your gonna be my hero

I never touched the MS, nor let it get lower than the min. line

ill let you know in the morning
 
Have you bled the LSPV?

Bleed that before bleeding the MC. Bleeding the MC (on the truck) is messy and not fun at all.
 
When I did my front brakes I had the same issue. I couldn't pull any fluid with my bleeder. So I dragged my wife out into the garage and bled the MC. Worked like a champ.

Any update?
 
bled the LSVP, and it didnt seem to have any air in it. I dont ever remember the level getting low in the MC, but i guess ill go get 4 clear hoses, and get to it.. Ill let you know about the MC asap.

thans for the help
ryan
 
The fronts are always going to carry most of the braking load and wear faster that the rears. Hence the four piston calipers versus two in the rear.

Were the rear calipers dry when you removed them? Did any fluid drain out of the lines when you removed them?
 
Nah, no fluid at all, today I disconnected the hose from one of the back calipers, and hit the brakes. No fluid at all. So i followed the line to the LSPV, and unhooked that and hit the brakes, NOTHING there either...
Still havent bled the Master Cylinder... Trying to dodge that, and the reservoir never got below the minimum line before i refilled it

The fronts are always going to carry most of the braking load and wear faster that the rears. Hence the four piston calipers versus two in the rear.

Were the rear calipers dry when you removed them? Did any fluid drain out of the lines when you removed them?
 
Back
Top Bottom