Real Time Weber help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 30, 2005
Threads
43
Messages
581
Location
Brevard, NC
Website
mofj40-1968.tripod.com
Just finished tearing apart and cleaning my Weber carb (F engine). Lowered the floats because it was running way too rich - smoking from exhaust constantly. Blew out the jets, wiped out the float bowl, etc. Reassembled and reinstalled. Reset the idle mixture to about 2.5 turns out from stop.

Runs great- no smoking. Starts in about 1/2 second with no throttle (timing is advanced somewhat). Idles fine, runs smoothly up to redline.

when I back of the throttle quickly, I get a little black smoke out the exhaust. More importantly, it's deiseling (knocking) when I shut it off. Is this a rich or a lean condition? If rich, how far out on the idle mixture can I safely go?

Note- truck ran great until about 2 months ago when it began to gradually get worse.

Thanks in advance for any suggestions.
 
First Guess

1. Dieseling is often a combination of too much advance and a rich mixture.

2. A timing problem is relatively easy to fix. Take your distributor to a shop with one of the old fashioned Sun testers and find out if your advance (vacuum and/or centrifugal) is working properly. If it's off, you can have the shop rebuild it and reset the timing. Once you know it's okay, then you can pop it back in and set your timing, using a light, not your ear, :-)).

3. The second might pose more of a problem. about 10 years ago, 2F owners had a choice between 2 Webers. Haven't kept up, so don't know the current situation. The 32/36, a 2-barrel with progressive linkage and the 38, a 2-barrel with straight linkage. The theoretical trade-off: the 32/36 had better low end performance because the 36 didn't open until needed. The 38 gave up some low end because both barrels work together, but had better top-end performance. Conventional wisdom back then: decide on distributor, cam timing and tuning of headers, then pick the carb to match.

4. Finally, to your black smoke question. Sounds like you're pulling extra gas through the carb when you get off the throttle. you might only have a jetting problem and Weber's tech support might be able to help. I recall telling them that I'd be using the 32/36 at 4000-5000 feet and having them suggest jetting. If, on the other hand you have the 38 and few/no other mods, you might be overcarbureted. And, not have noticed until you cleaned the crud out of your carb. There are few inexpensive fixes for too big a carb.

5. Hope somebody can give you more information and less speculation.
 
You need to re-jet if it was running too rich. I am not really sure if lowering the float will help that. But too low of a float could cause a bucking problem at speed when the carb runs out of fuel in the bowl.
 
mobiltoy- southwest missouri, near Joplin


others- thanks for the advice. I got it running late last night. fabbed new connection from stock air cleaner to carb- I think it was leaking air and allowing the carb to overdraw. Also found crack in fuel line at carb causing variation in fuel flow. I think it probably happened when I pulled it to adjust the floats. I love how the fuel line/ carb connection sits directly over the exhaust manifold. It keeps things interesting.

Readjusted the idle mixture and it's running great now.
 
mofj40 if you ever make it over near St. Louis hit me up with an email. Bill
 
Back
Top Bottom