Real Time T-case help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 8, 2004
Threads
45
Messages
1,044
Location
Houston, Texas
I have the t-case sitting on the bench. It's a heavy bastard. I am trying to install the front output and I can't get the gears of the clutch sleeve to mate up with the drive clutch hub.
I have a sneaky feeling I should have locked the cdl BEFORE dissasembly. Anyone have a suggestion? What about pulling the motor actuator to set the cdl in the lock position? Any advice would be greatly appreciated.

JSYK, I was replacing the front output seal and dropping in a new bearing as well.

Buck
 
Last edited:
Bunp for some help
 
I would imagine I could supply the volts. I am an electical idiot and have no clue how to go about this. Could someone enlighten me about about how to supply 12 volts to the diff lock sensor? As in what color wire do I connect the positve to, what kind of battery, etc. I really need the basics here.

Buck
 
Wish I could help...but here's a bump for ya...
 
UPDATE-
I tried applying the correct voltage to the diff lock with no luck. I don't know why I didn't think about it but a buddy came over to give me a hand at this. His idea was to slide case under the truck and reconnect the actuator . Didn't work and Gary says "we need a ground". Run a junper cable from the t-case sitting on the ground to the tranny. Gary pushes the difflock switch after I manually lined the up the clutch sleeve and bingo, on she went. Front ouput is on. I am renting a lift at a shop for an hour tomorrow for the install.


AS A REMINDER when pulling the front output of the t-case, lock the center diff first.

Buck
 
Back
Top Bottom