Real Time Help! Quick question about distributor O ring

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 16, 2006
Threads
60
Messages
341
Hey mudders-
Bout to finish up replacing my distributor O ring and had a quick question. I put the O ring in the groove and while putting the distributor assembly on, it pushed back to this location. Is this where the O ring ends up? Does it seal when i tighten up the distributor bolt? Once i'm done, i'll do a write up with pics!
Thanks!
o ring.webp
 
I have done exactly one of these !

But, I do not believe that O-ring is supposed to be visible outside like that. ;)

Try some grease or vaseline on the o-ring to keep it in it's groove.

HTH's !! :)


Britt
 
i wasnt sure if the O ring was suppose to go on the inside of the valve cover (bout half an inch where i originally put in in a groove). When i took the distributor off the first time, i didnt even see the original O ring! Is it suppose to stay in location B?
o ring 2.webp
 
Yep. B location.

I'd look around for the oring. It will be black instead of red like the new one. It's gotta be there somewhere unless it fell down into the timing chain cover.
 
1) Remove distributor
2) Remove OLD o-ring
3) lubricate NEW O-Ring
4) Install new O-ring into groove
5) Clean the hole the distributor slides into and lubricate it with engine oil
6) Install distributor in correct alignment, making sure the O-Ring is COMPLETELY inside the head.
7) install and tighten the adjusting bolt in the correct location.
8) Check timing.


Are you sure you should be doing this work? If replacing the O-Ring was that hard, are you going to be able to get the distributor back into the correct location and timed properly?
 
85x look what you've done. This thread has only been dead for 10 years everyone
 
Last edited:
85x look what you've done. This thread is dead everyone
Damn, we all want to help so bad, we just post without thinking.........
 
Back
Top Bottom