REAL TIME HELP gas struts

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 28, 2014
Threads
15
Messages
371
Location
Campbell Hall, NY
assembling my 4x4labs rear bumper with double swing-outs. Supposedly there's no such thing as a stupid question, but I'll try: how does one compress the 15" gas struts to install them?
Prompt help appreciated since I want to go wheeling tomorrow :)
 
I used a small piece of 2x4 and a helper. You connect the end that goes to the bumper shell, then you have your helper hold and align the other end while you shove on it with the 2x4. It can be a real B. Another way to do it is unbolt the swingout from the spindle, attach both ends of the strut, then force the swingout back over and down onto the spindle. The weight of the thing will help you compress the strut if you don't have a helper.
 
assembling my 4x4labs rear bumper with double swing-outs. Supposedly there's no such thing as a stupid question, but I'll try: how does one compress the 15" gas struts to install them?
Prompt help appreciated since I want to go wheeling tomorrow :)

Make a harness using a series of HD zip ties looped around each end. Compress and tighten zip tie holding two end loops together. Install compressed and then just cut the zip ties. I use this method with shocks and it works well.
 
I put my swingouts on the spindles, but did not install the nut. Lift the arm up a little bit so it no longer hits the stops--that will let you open it farther, and attach the gas struts. Close the swingout, and wiggle around until you get the bearings to seat properly again. Done.
 
Make a harness using a series of HD zip ties looped around each end. Compress and tighten zip tie holding two end loops together. Install compressed and then just cut the zip ties. I use this method with shocks and it works well.

I didn't have any HD zip ties here. They're at my other house 2-1/2 hrs away. But your suggestion gave me an idea: looped a ratchet strap around the shock to compress it. Slipped it over the ball studs, and voilá! I did that on the DS swing arm, which I had already tightened up, and set the spindle cap. Thank you for the inspiration and the quick response!!!

IMG_5417.webp
 
I put my swingouts on the spindles, but did not install the nut. Lift the arm up a little bit so it no longer hits the stops--that will let you open it farther, and attach the gas struts. Close the swingout, and wiggle around until you get the bearings to seat properly again. Done.

I was able to try this on the PS swing arm, since I hadn't started on that side yet. This worked so easily...Made me feel like a real idiot (a role I'm settling into on this project).
Thank you so much for your prompt reply and a simple, effective, one-person-can-do-it suggestion!
 
Back
Top Bottom