Real time help Error code 25 too lean?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

supercarrera

Club Esprit de Four
Joined
Dec 20, 2006
Threads
117
Messages
1,108
Location
Santa Clara, CA
Website
www.instagram.com
Help im on my home stuck in mammoth with this code with lots vibration.
 
hmmmm, burnt wiring harness by the EGR? Burnt wires by the O2 sensors? It could be lots of things. Can you give a better description of the problem, the symptoms and exactly what you were doing before it happened?
 
Worst case scenario, drive it home in diagnostic mode. ie, leave the paper clip in there and go.
 
Hi,

I posted this from my cell phone on Monday when I was in Mammoth. That's why there wasn't too much info. But here's what happened and is happening:

Was heading up 395 and the truck felt like it was misfiring. Suddenly, there was a severe loss of power but it still ran. The check engine light also came on. So I limped it into a garage where the guy read the code as 25. Well the closest dealership was 60 miles away in Bishop and I understood there was a long waiting list there. So I decided to limp it home. Went over Tioga pass doing around 20 miles an hour without pushing it. The check engine light came on briefly, then went off again. Somewhere through Yosemite it started running fine again all the way back to San Jose.

So I thought it was okay. I've been driving it. It did act up again however a couple days ago but was fine after it sat for a few hours.

Cappy those were my immediate thoughts too. Either the wiring or the oxygen sensors. Plan on replacing the sensors. They probably need it anyway. And I'll be checking the wiring as soon as I get a chance.

Scott
 
Keep us in the loop. Good luck.
 
Back
Top Bottom