Real time Help Engine/Tranny

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 17, 2004
Threads
58
Messages
191
Location
upstate SC
I just rebuilt my 1FZ (long story) and I dropped the engine back in over the weekend. I installed all of the bellhousing bolts and torqued them to spec. OK, next step: install the torque converter clutch bolts. Oops! The flywheel and torque converter are not aligned and I cannot get them to move separately. :frown: :frown: I went back and loosened all of the bellhousing bolts, but still no success. Any suggestions??? :confused:
 
Back
Top Bottom