Real time birf help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 13, 2007
Threads
108
Messages
479
Location
Arizona
The rear retainers for the seals. The balck one that come is two half moon pieces. the ones that seal the felt seals. Does the lip face outwards towards the wheel or inwards towards the axle?
 
Cool we did it right
 
I read thru the FAQ but cant figure out how to dissasemble the Birf from the axle. The FAQ just shows the birf in a vice.
 
I should have mentioned I needed to purchase a new birf and spindle when the bearing went it ruined both. Plus there is clicking. Problem is we already have one side done why waiting for the new birf to arrive from Slee. And we didnt do the switch. Oh well
 
I should have mentioned I needed to purchase a new birf and spindle when the bearing went it ruined both. Plus there is clicking. Problem is we already have one side done why waiting for the new birf to arrive from Slee. And we didnt do the switch. Oh well

OK. So do you have the one good birf apart or do you need to know how to take the axle out of the birf bell housing? Also, which side are you working on--long or short?

-o-
 
We have reassembled the drivers side. This is no longer Real time. We are done for the night and sitting idle till the rest of the parts arrrive (Birf from slee). I need to dessasemble the passenger side birf from the axle so it is ready when the new birf arrives
 
I dont know how to take the axle apart from the Birf.
 
Anybody?
 
Follow the FAQ. I just did it a few months ago. THere is a section in there that talks about getting a pipe that is slightly larger than the axle shaft, sliding the axle into it, and dropping it a few times till the inner ring either bends, or breaks away from the birf. Look at the FAQ section again...
 
OK ill check
 
Back
Top Bottom