real time 3 speed xfer install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 14, 2003
Threads
78
Messages
4,571
Location
Colofornia
I'm reinstalling my 3 speed xfer on the back of the tranny and I have have 2 spacers. I'm assuming one (thicker one) goes between the drive gear and the pto gear and the thinner spacer goes behind the pto gear.

I looked in the fsm and it only shows one spacer after the pto gear

I searched briefly here but may not have spend enough time finding the answer.

Is the above correct?




now where did i put posers # :doh:
 
Have you tried to assenble the tcase to see if what you are asking works?
 
I have and it does.. I asked ige and tree if they remember but they don't. I guess I was just hoping for confirmation as i'm not pulling this again for another 42 years.

I had the large spacer sitting with the drive gear and the little spacer with the pto gear. I know the spacer doesn't go in front of the drive gear, so it's pretty much gotta be it.

I have got to start using the digital more :frown:
 
I am not aware of a 'little' spacer on the stock three speed set ups...


There is a spacer that could be used in place of the PTO gear, but the only other spacer that I remember goes under the rear PTO cover(tin cone affair) and that is stepped internally and only can fit there.


Post up some pics of these spacers bud.


:beer:
 
I will venture to say the thin spacer does go in front of input gear. Please refer to treeroots write up thread on orion install. He cover the oem spacer deal for the input shaft in depth.
 
yeah but that is radically different. He's got an sm465 with a stub shaft and no pto.
If you can post the link that'd be cool but I venture to say that thread doesn't have any info.

here are a few pics.. everything is lined up. The Drive gear is lined up and the rear bearing on the housing is too. I just don't know where the pto is supposed to sit.

1 loose
1 tight
1 of the rear output with the gear and nut snug but not tightened. It could probably get a little be more as i didn't do any of the t case bolts.
116_1659.webp
116_1663.webp
116_1660.webp
 
The spacers and location of the PTO gear mean nothing if you are not running a PTO.

Run it..
 
I just don't want to redo it when I put a stock pto in.

I went and pulled the cover off my 66 at treeroots and the gear is length on the shaft is totally different and it's the same as what I see in the FSM. The PTO gear against the drive gear and then a spacer. I guess mine has a wierd pto gear.

This is what I was expecting to see. Anyway you can see the pto is lined up with the inside of the idler gear.
pto.webp
 
Back
Top Bottom