Re-use OEM shock hardware?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 16, 2007
Threads
17
Messages
100
Location
Jupiter, FL
I didn't see a complete set of hardware in the box with the new set of OEM shocks. You guys that have replaced stock for stock shocks, did you re-use the nuts n bolts or get new stuff from the dealer?

Thanks

Jason
 
Last edited:
Where did you get the OEM shocks from? When I ordered mine from cdan, the only things I had to reuse were the big metal washers (front and rear), rear lower bolt and rear top shock plate and bolts. I know mine came with new front lower nuts (because I had to cut my old ones off to get the front shocks out) and I am pretty sure that it had new upper nuts with the front shocks.

They should have come with new rubber bushings (big rubber spacers that look like small skateboard wheels) and new top and bottom nuts for the front shocks.

Riley

edit: I did not need to buy any additional hardware (just needed to reuse the items listed above).
 
Last edited:
OK, maybe I should go through my boxes again. I remember that the rears only had bushings, so re-using the stuff you mentioned is fine.

I got the shocks from CDan, too, and I'm sure the packages are complete. Maybe I was in a rush while looking through.:whoops: Will try again.

Thanks for the info.
 
Could have sworn there were new front upper nuts, I guess not. Just be careful when you remove everything. If you read about my experience, the front shocks took a little bit longer.

Riley
 
Back
Top Bottom