Rad flush PLEASE HELP!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 30, 2009
Threads
8
Messages
19
I have a 1997 FZJ80, and I am attempting a back-flush with a prestone kit. I am not positive which hose to cut and install the tee. There are two hoses that merge into one at the firewall, then go into a hard line that ends right above the thermostat housing. Is this the one? Any FAST help would be appreciated as I have already removed the brass plug, and emptied the radiator. PLEASE HELP A NEWBIE!!
 
Right, I have read that, but it doesn't really say which hose to cut...Is it the one I described? Thanks.
 
I just went through this last weekend - I didn't cut the hose in the end, just looped a longer piece of 5/8th around so it didn't kink and turned on the hose. That way I could return the system to factory after as I didn't want to leave the plastic T in.

I followed e9999's guide below - and THANKS to e9999 as his guide and photo's made everything totally clear.

So coming from the engine front back towards the firewall the sequence was

Return house (starts in the thermostat housing and ends after the S shaped hose e9999 cut) -> Prestone T -> long loop of 5/8th -> the T near the firewall where you just disconnected the return hose

Photo 4 of e9999's writeup shows the area pretty clearly.

More joints = more points for problems to occur IMHO.

https://forum.ih8mud.com/80-series-tech/14891-cleaned-my-cooling-system-full-scoop.html
 
Last edited:
Just did this on both trucks. On the 97, I used the hose you describe near the firewall that descends to a hard line that connects to the thermo housing. I simply held the sprayer against that hose and blasted the heaters clean. That's the hose I'd use if I were installing a T.

On 93/94 models, this rubber hose goes forward farther before connecting to the hard line and you can obviously use this same hose.

DougM
 
Back
Top Bottom