R&P break-in

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 31, 2008
Threads
47
Messages
150
Location
Boulder, CO
Ok, so I'm the process of breaking-in my new 4.88's, and noticing some noises/grrr's. Is it normal for the new gearsets to make some noise while they are going through the break-in period. Specifically, at higher speeds (right around 50mph. won't go faster until I reach 500 mi.) there is a noticible grrrr when transitioning from drive to coast. Also there is a subtle gear whine at all speeds (very high freq.) Any help is appriceated.
 
gears

Noise is not normal during break-in period. If it is a grrr sound it likely is a driveshaft related noise. If you arent running CV and didnt notice the sound before, it can be amplified by the gear change since the driveshaft speed has increased. Additionally, if the pinion bearing preload was not set properly, or if the bearing races seated after install and loosened them up, you can get this sort of noise. Gears dont really "grrr" on the float, if they are noisy they will more often make a whining noise.
 
Thanks for the info, I had some rear driveline vibes before the gears were put in, I suppose the gears are just amplifing the prob. I will take out the rear driveshaft and see if everything is better. On another note, I had the rear driveshaft done right befre the new gears ( new u-joints, balanced etc. by a certified spicer driveshaft shop). He used spicer 5-1511x u-joints on the shaft and told me it was good to go when I picked it up, but I got some vibes after putting it on. Are the u-joints to blame, should I go with toyota joints? Anyone have issues like this before?
 
Thanks for the info, I had some rear driveline vibes before the gears were put in, I suppose the gears are just amplifing the prob. I will take out the rear driveshaft and see if everything is better. On another note, I had the rear driveshaft done right befre the new gears ( new u-joints, balanced etc. by a certified spicer driveshaft shop). He used spicer 5-1511x u-joints on the shaft and told me it was good to go when I picked it up, but I got some vibes after putting it on. Are the u-joints to blame, should I go with toyota joints? Anyone have issues like this before?

Do you have adjustable upper control arms to fix the angles on the rear driveshaft? It could be the spicer joints if they don't seat perfectly, but I'd be checking angles, too, with a vibe on decel coasting.
 
The driveshaft could be fine too. It is more likely an issue with angle. To adjust the pinion angle you can use some adjustable upper control arms like Slee sells. Some vehicles are still to high to adjust the vibes out and may require a cv driveshaft. If running a cv you will point pinion towards tcase. if std single cardan, you would want the pinion angle parrallell to the tcase output.


Thanks for the info, I had some rear driveline vibes before the gears were put in, I suppose the gears are just amplifing the prob. I will take out the rear driveshaft and see if everything is better. On another note, I had the rear driveshaft done right befre the new gears ( new u-joints, balanced etc. by a certified spicer driveshaft shop). He used spicer 5-1511x u-joints on the shaft and told me it was good to go when I picked it up, but I got some vibes after putting it on. Are the u-joints to blame, should I go with toyota joints? Anyone have issues like this before?
 
Back
Top Bottom