- Joined
- Mar 27, 2003
- Threads
- 147
- Messages
- 2,610
I made my own headlight harness years ago. Identical to the one Slee sells.
Today as I drove home I noticed my lights didn't work. Highs did but no lows.
I saw the low inline fuse housing was melting. I figure this was due to my poor placement of the fuses under the hood. Water slowly erroded them and with such poor contact can I assume the energy dissipated as heat??
I just replaced the two inline fuses with waterproof holders and both low and high work fine without any aberrant heating.
My question is this:
For the life of me I cannot remember ... when you engage the high beams do the LOWS stay on as well. Mine now are.
I swapped out the two relays in my lighting harness and the behavior remains the same -
My lows STAY on with the highs...
*chuckling at myself*
I just can't remember
Thanks,
TY - *senility setting in*
Today as I drove home I noticed my lights didn't work. Highs did but no lows.
I saw the low inline fuse housing was melting. I figure this was due to my poor placement of the fuses under the hood. Water slowly erroded them and with such poor contact can I assume the energy dissipated as heat??
I just replaced the two inline fuses with waterproof holders and both low and high work fine without any aberrant heating.
My question is this:
For the life of me I cannot remember ... when you engage the high beams do the LOWS stay on as well. Mine now are.
I swapped out the two relays in my lighting harness and the behavior remains the same -
My lows STAY on with the highs...
*chuckling at myself*
I just can't remember
Thanks,
TY - *senility setting in*
