Questions about wheel backspacing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 13, 2006
Threads
114
Messages
634
Location
West of the Pecos
QUESTION: wheel backspacing???

Here's the main question: Less backspacing equals tires sitting wider on the ground, correct?

I was thinking about a set of OEM steel wheels, but they are pretty expensive compared to some of the other wheels on the market. I have a set of 265/75/16's but may change to 255/85/16's - For those tire sizes, 16x7 with 4" backspacing might actually be better than OEM, right?

Specifically, anybody know anything about these wheels?

http://www.4wheelparts.com/PDT63619.aspx

Thanks!
 
Last edited:
Nobody knows nothin', huh...



:confused:
 
The larger the number, the more the tire will be pulled under the vehicle.

Backspacing is the measurement from the inside lip of the wheel (on the back) to the mounting flange.

Imagine laying a wheel flat on the ground with the good side in the dirt. Then lay a yardstick across the wheel. You would measure from the mounting flange (where the lugnuts go through) up to the yardstick to obtain the backspacing.

So, yes- you are correct about the being wider. Don't know the answer to your question relative to tire size and 4" BS. However, we all know that 4.5" works best. Those wheels, as pretty as they are:rolleyes:, could probably be found with the "correct" backspacing. Nearly every wheel manufacturer makes some variant of that wheel.
 
A 7" wide wheel with 4" BS should be equal to an 8" with 4.5" BS, except that the rim is an inch narrower. Combining that with a 255 tire should be ok, assuming both the wheel and tire have sufficient load ratings for the 80. Be aware though, that a narrower tire and wheel may change the handling characteristics of the vehicle and may make it feel more tippy when cornering.
 
I went with a 15x8 with 4.25" backspacing and the 80 handles great. I'd suggest something like that for a good compromise. They're the American Racing black steel wagon wheels...couldn't be happier.
 
A 7" wide wheel with 4" BS should be equal to an 8" with 4.5" BS, except that the rim is an inch narrower. Combining that with a 255 tire should be ok, assuming both the wheel and tire have sufficient load ratings for the 80. Be aware though, that a narrower tire and wheel may change the handling characteristics of the vehicle and may make it feel more tippy when cornering.


They make this same wheel 16x8 with 4.25" backspacing, so I'll probably just go with that, since there seem to be a few guys running 255's with OEM wheels and no apparent problems. I just wondered if 7" wide wheels would actually be BETTER with 265's or 255's, since those tires are both pretty narrow.

As far as how "pretty" they are - never crossed my mind. Just looking for some decent steel wheels that won't break the bank, to replace the "blingish" shiny chromed alloys that were on the truck when I bought it... IF ANYBODY HAS ANY BETTER SUGGESTIONS FOR WHEELS UNDER $100 EACH, I'M ALL EARS!

A set of 5 OEM steel wheels would probably eat up $1000 by the time I got them on the truck, but if I wasn't a po'boy, that's what I'd opt for.
 
Back
Top Bottom