Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Colorado Boy-74-FJ40

I may grow older but I refuse to grow up!
Joined
Aug 5, 2005
Threads
83
Messages
1,461
Location
Windsor Colorado
I am in the process of stripping and prepping my tub for a bed liner job. There is minimal rust (lucky) I do however need some advice on how to repair the fender well rear folding bench attach point. I,ve attached some pics.
spot.webp
hole.webp
removed piece.webp
 
more pics

Here are some pics of the floor. The blue stuff is bondo that I am using to fill in the small divots left behind after I removed what little rust there was. I used naval jelly and a pressure washer. The gas tank had minor rust where the bottom mounting pads were . No rust in the tank well at all. I primed the tank and coated the bottom side with the bedliner I'm going to use on the tub. The tank had no interior rust remarkably. I looked in with a mirror and flashlight. I'm lucky that the rig was in a dry Colorado climate for so long and there is little repairs to do. I just would like some ideas on how to fix the seat mounting points.
dr.floor after.webp
pass floor after.webp
gastank.webp
 
Back
Top Bottom